Видео

Does oil coolant work good in that honda

It’s NOT a 9mm bolt on the block. Please correct. I just burned an hour trying to make it work.

Greetings... please. What is this regulator used for? Is it for medical purposes only or for food purposes? Also... Can I use it to make soft drinks?

The Toyota engineers who designed this need a raise.

If you drain the coolant from the engine block and refill with new coolant, will engine block receive any new coolant since the thermostat will not open until the temp reaches 180.

Should do a coolant test to see if coolant needs replacement. There are test strips or a probe to test the coolant.

Saying process on a three thirty c I two thousand four I would imagine

He didn’t show how to get the tube on the engine block drain.

1:23 looks like you wearing an orange leopard thong

Why are you calling The brake bleeder the banjo bolt? Had to stop watching video immediately

Thank you so much! I have a doctor's appointment tomorrow and I need to switch my tank. You taught me how.

You're to damn slow and boring

By the time he's finishing up mixing the stucco work day is over

turn lights off while filming??? some reason for this?

doesnt wirk and who has this stuff

thanks for thw video it was very helpful

Just replaced the pulley on mine with your help. Made my idle much, much better, but still some movement, especially with the AC on. I'm going to look at the motor mounts eventually. Thank you for all of your help.

Great job thanks so much iam new with oxygen just got over asthma pneumonia bronchitis

You didn't show the removal of the bottom screw. Because you have to get it from the bottom right side. You didn't the hard way.

You suck.

That's a bloody hard way to mesh a trench footing. Can you not buy different width trench mesh over there? When I have to do a wall footing or trench I just buy either, 3 or 4 bar width and if need to be boxed I just buy the appropriate stirrups

Super helpful!

Three minutes times up.

Whats the size of that wrench?

Thank you so much!🤗💕

would an impact wrench be tool of choice ?

The gravel is already clean.

Ok

I had a similar thing happen at Home Depot. I was buying a wool cover paint roller and noticed that the color looked a bit off from others in the bin. Some low-life had swapped the expensive wool one with a $2 cheap one, and saved money by ripping off another unsuspecting customer. I noticed, and handed it to the HD employee with the suggestion that it be thrown away.

You can put the Teflon tape further down the threads. When you tighten the anode rod, the threads will cut through the tape and make metal-metal contact. I always check that with an ohm meter, just to be sure, but it always does.

Is the color coat mix the same or thinner?

Spray PB blaster a few times and let it work for a few hours. Use a breaker bar to loosen the nut.

1:47 why this nigga wearing a thong?

Are the blocks filled with cement?

THANX

Thank you😊

It is a great work :}

Fantastic and very helpful.

I stripped mine so bad it'll never come out.

holy F*#K !!!

not much talk about how to mix

Thank you! Very helpful for newbie’s

Easier way to do that is take a hammer and tap on the end of the break over handle with short but firm taps. With just a little patience it will come loose. No need for all of the straps.

Does anybody know why my car only works when its cold after about 30mins of run time it doesn’t want to start .. my hand does goes all the way to H it just stays in the middle

Such a great help. The water pump pulley was a struggle to get on the new pump. Thank you for the video

Brother look leave it too the experts please just saying.

Thank you for the video, RandomAZdude. I just checked your channel and did not see any more computer videos, so I cam e back here to see if you or anyone possibly watching this video in 2023 can answer a question about this procedure. This is April of 2023, it looks like this video was from about 10 years ago, and obviously computers and operating systems have changed since this was posted. Does anyone know if this still applies using Windows 11? That I can just buy the hard drive adapter / case, install the old hard drive and plug it into a newer laptop running the latest software?

My computer fell when I was moving furniture and my computer guy says he can't get anything from the hard drive. I took the hard drive out. Will it do me any good to do this? Do you have a video that can help me get my files?

how come, you did not follow sequence and started in the rear?

Excellent tutorial vid buddy! Thank you for your effort. You made it look much easier than I expected. Well done. 😅